Blown Away
New member
Wiz,
Having problems with my burner. Just starting a job this morning and turned on the burner and after a couple of minutes steam started coming out of the wand. I had my x-jet nozzle on and water and steam was coming out of the nozzle and steam was coming out of the syphon attachment ( I did not have the tube hooked on at that time). Turned off the burner ran it to cold water, shut down, replaced burner nozzle (with the assumption that it was getting too much fuel) and started again and stumbled upon the problem over again. Any help would be appreciated. Thank you in advance.
Steve
Having problems with my burner. Just starting a job this morning and turned on the burner and after a couple of minutes steam started coming out of the wand. I had my x-jet nozzle on and water and steam was coming out of the nozzle and steam was coming out of the syphon attachment ( I did not have the tube hooked on at that time). Turned off the burner ran it to cold water, shut down, replaced burner nozzle (with the assumption that it was getting too much fuel) and started again and stumbled upon the problem over again. Any help would be appreciated. Thank you in advance.
Steve