surface cleaner

P

paul-uk

Member
i was 30 minutes from finishing the job today and i started getting zebra stripes.....turned it on it side and only one jet was working..i didnt have time to look then but will do in the morning.

is the problem a blocked jet .what do you use to clean them.

thanks paul.
 
Your Nozzle is cloged , take it off and tap it on a hard surface , it should fall out , it not , go buy a torch tip cleaner there $3 .

Mel
 
ron p/mel

now why the heck did'nt i think of that?
At the welding shop they also carry the coolest safety sunglass's.\
Also fire exstinguishers.
 
[B]mel[/B]

you was right...i have a filter on the uptake from the tank....i have a ball valve on the connection end to the s\cleaner....i dont fancy putting a filter there aswell ??

cheers paul.
 
ron p/paul

2 things paul.
On start-up, dont put anything on the end of the pressure line.
Start your unit and your burner and let run for 1 full min.
This will purge the junk out.
Second if you get more then 3 clogs per month, it's time to de-scale the coil.
Also think about stainless steel fittings.
 
thanks ron

i am running a cold machine at the moment..on startup i have nothing on the hose and have the ballvalve open when starting i let it run for a bit and wet the grass\plants while doing it.

i have brass with a s\s coating..will get s\s next time i buy...i think the crud is from the tank...it was in poor order when i got it.there must have been some particules left after rinsing it.

thanks paul.
 
You must log in or register to reply here.
Back
Top