Setting up new trailer, need help with Tank Setup

[MVPPOWERWASH]

Hey everyone, I'm in the middle of building my new enclosed trailer that I posted about in another thread. Never had a holding tank before but adding one to this trailer. I'm thinking about using 1" Polyester Reinforced Clear PVC Tubing. Would anyone recommend anything else? What fittings are you guys using? PVC Barbed fittings? Any help would be most appreciated on what else others are currently using so I don't have to re-do it again in the near future. Thanks!
-Jeff

 

[El Flojo]

I use 1" poltbraided hose to feed the PW

 

[MVPPOWERWASH]

The 1" Reinforced is the Poly-Braided. I was going to use that from the Tank to the Pump and have a 2" Dump under the tank. Then run maybe a 3/8" Hose from chem tank to Injector and run the line through PVC to keep it from turning on me and coming up to the surface. Anyone have any pictures of how they ran their lines or where they put valves, etc? Thanks!

 

[Connor]

I used a 90 gal buffer tank, now I use only a 35 gal, no need for me to have anything larger for now.

 

[offdutyfireman]

one trailer set up

 

[Steven Button]

William, where did you get the 3-way ball valves - do they hold up to the bleach?

thanks :yes4:

 

[offdutyfireman]

Espec. They last about 4 or 5 months. They are about $25 each if I remember right.

 

[Steven Button]

thanks!

 

[MVPPOWERWASH]

Thanks for the help so far guys.
With regards to those 3 way ball valves, not to sound dumb but I'm assuming there is an Intake like from a chem tank and 2 out lines to each hose reel? Also....did you try Marine Stainless with full Stainless guts? I switched to them for some of my Ballvalves last year and have only lubricated them on a regular basis and they are holding up to everything. Big stores like West Marine sells them in all different sizes.

 

[Johnson]

Thanks for the help so far guys.
With regards to those 3 way ball valves, not to sound dumb but I'm assuming there is an Intake like from a chem tank and 2 out lines to each hose reel? QUOTE]

Not sure if they are setup like that since you have to switch ports with the handle. I believe the intake is the d.s. injector and the outputs go to the chemical tanks, water tanks etc.