Quick connects on spinning bar of surface cleaner??

Clean County PW

Clean County PW

Active member
Is this possible to have where the tips would stay in the right position? The reason I ask is because I have 2 powerwashers set up in my van where one is a 4000psi@4gpm and the other one is 3000psi@3.5gpm.

Instead of lowering the pressure via the adjustable unloader where I will decrease the GPM on the 4000psi PW to make it 3000psi is it possible to put quick connects on the spinning bar so I can match the pressure up with these two machines when in use?

If not it looks like I will have to change the tips on the bar via the old fashion way with the use of a wrench(A pain).

Also if this can't be done they should make special quick connects for these machines where they can be locked in place so the tips can't go out of position when not in use(When the wand is not squeezed and there is no pressure going thru the tips where they can go out of position before the wand is squeezed again)
 
If you look at a nozzle chart you will find that both machines use the same tip size. Therefore your problem is not a problem the twister and wand are interchangable on both machines without changing any settings. Both machines require a #4 tipThe twister should have 2 #2 tips.


attachment.php
 
Last edited:
try a #4.5 or a #5 the volume will stay the same but the pressure will lower. Larger

Click on this link to see a nozzle chart!

attachment.php



look up at the top of the chart for the PSI follow it down to the required GPM then across to the left for the Tip size .
 
Last edited:
You must log in or register to reply here.
Back
Top