Incomplete Directions:
Mix about 2 inches of brand "X" chemical (into a 5 gallon pail) with 1/2 gallon of Sodium Hypochlorite then fill the rest of the 5 gallon pail with water, then X-Jet.
- Is that an engineer's or a carpenter's 2 inch?
- What was the intended final mix ratio?
- What % Sodium Hypochlorite should I use? 5-1/2%; 6%; 12%???
- What is the assumption of the X-Jet mix ratio in the open mode?
I have a 3 GPM, 4 GPM and a 6GPM pressure washer. Will the above mix provide identical results on the same surface?
Am I wasting my chemicals?
Am I spending too much money or time per job?
Regards,
Mix about 2 inches of brand "X" chemical (into a 5 gallon pail) with 1/2 gallon of Sodium Hypochlorite then fill the rest of the 5 gallon pail with water, then X-Jet.
- Is that an engineer's or a carpenter's 2 inch?
- What was the intended final mix ratio?
- What % Sodium Hypochlorite should I use? 5-1/2%; 6%; 12%???
- What is the assumption of the X-Jet mix ratio in the open mode?
I have a 3 GPM, 4 GPM and a 6GPM pressure washer. Will the above mix provide identical results on the same surface?
Am I wasting my chemicals?
Am I spending too much money or time per job?
Regards,