planethopper
New member
What could cause this? The water temp dropped about ten uses ago (I use it about two hours a week) then the last time i used it it just stopped making hot water.
My dynoblast stopped making hot water!
- Thread starter planethopper
- Start date
JohnB
JohnB
http://groups.msn.com/Hotwaterwizard/wayneburner.msnw
This a link to burners by the hotwater wizard...... may help
This a link to burners by the hotwater wizard...... may help
Hotwaterwizard
Hotsy Service Tech
Did it run out of fuel?
If it did and you put more in, Check the fuel filter. Also check the Thermostat setting. It is not uncommon to have the dial Vibrate to a lower setting. If that happened you can fix it by pulling off the knob and installing 2 small O-Rings on the shaft and stick the knob back on. The friction of the O-Rings will stop the Temp knob from moving easy again.
If it did and you put more in, Check the fuel filter. Also check the Thermostat setting. It is not uncommon to have the dial Vibrate to a lower setting. If that happened you can fix it by pulling off the knob and installing 2 small O-Rings on the shaft and stick the knob back on. The friction of the O-Rings will stop the Temp knob from moving easy again.
planethopper
New member
No, didn't run out of fuel and the temp dial is at full.
Is there a common thing that goes on these machines or can it just be a number of different things? My machine is an H4035DGF.
Is there a common thing that goes on these machines or can it just be a number of different things? My machine is an H4035DGF.
Russ Johnson
Equipment Expert
Which Dynoblast do you have? I believe they're private labeled by Epps. If the temp dropped off earlier, the fuel filter might be clogged or the thermostat may have gone bad.
Hotwaterwizard
Hotsy Service Tech
Sooted up coils can also cause this.