Landa pgdc5 control box wire issues

[gooch22garcia]

Can someone please help me I have I landa PGDC 5-3500 n I bought it not knowing someone had messed with the wires inside the box with thermostat. Can some please tell me how to wire the 12v relay(flow switch, thermostat, rectifier/ bridge, led, switch, circuit breaker , fuel solenoid) thanks!

 

[milolieng]

Hello welcome. When I saw the topic, I said I will research it for you and I looked it up a bit. Where did you buy it? And they didn't give you an instruction manual when you got it? Believe me, I've read a few of his booklets that include such procedures. If you lost it, be sure to request it again. Respects...

 

[Hotwaterwizard]

Found an old diagram

 

[Hotwaterwizard]

 

[Hotwaterwizard]

Will look for the actual diagram at work

 

[gooch22garcia]

I've replaced 12v relay in control panel n I have a diagram that a hotsy rep sent me n I have it wired the way it says but still no electricity to the led

 

[gooch22garcia]

In this diagram it shows a hi limit n not a thermostat

 

[Hotwaterwizard]

In this diagram it shows a hi limit n not a thermostat

Wired the same the snap switch is the thermostat in the diagram

 

[Hotwaterwizard]

All you are doing is shutting off the fuel when the flow stops or temp is to high start with the power to one side of the flow switch other side of it goes to c on the thermostat then p1 goes to one side of the fuel solenoid in series with eachother

 

[SherrYth]

Have you figured out how to make it?

 

[willfrench]

Why don't you look for videos on this subject on YouTube? There are several blogs where people demonstrate how to make, repair, or replace anything. I mean, I went from finding the simplest how-to videos for these bulbs https://www.vont.com/product/vont-bulb-color-smart-light-bulbs-smart-bulbs/ to finding the most difficult quantum physics lectures. So, go ahead and look there. I'm not sure whether you'll discover exactly what you're looking for, but I'm confident you'll find something that will help you determine what you can attempt.

 

[morisson]

If I were you, I would turn to the Internet to look for different instructions or diagrams for this device. There are a lot of trolls on the internet, so I would not recommend trusting the advice of users who write to you here, as their information will be 90% not working, or useless, of course, except for some specialized forums. Just launch your browser and go to for example the new url for the pirate bay, and there you start looking for what you need.