Beverage Truck

AquaMike

AquaMike

New member
Has anyone ever used an old beverage truck as a wash unit? I'd think it'd work quite well with all the doors that are available. If you have I'd like to know how you layed it out for ease of use.


Thanks,
Mike
 
One concern is where would you put the water tank as it is divided down the middle for the sides of the truck for the storage compartments, you might have to lose maybe 1/2 of the front compartments to put in a new floor for support of a large water tank.

The rest of the equipment can be installed no problem I think.

There would be a lot of room in the storage doors once the water tank issue is handled.
 
Christopher said:
One concern is where would you put the water tank as it is divided down the middle for the sides of the truck for the storage compartments, you might have to lose maybe 1/2 of the front compartments to put in a new floor for support of a large water tank.

The rest of the equipment can be installed no problem I think.

There would be a lot of room in the storage doors once the water tank issue is handled.
Click to expand...


I was thinking some of the tall narrow water tanks and cutting out a wall or two but not sure how much support that inner wall is actually doing.
 
Each side should hold something the size of a pallet. A tote tank ought to drop right in. I would check for floor support to be sure, but stacks of beverages probably weigh some too.
 
seems like it would be a cool setup. alot of room and they sit pretty low, as long as you werent getting into gravel roads and areas with ruts in them, one of my trucks is a low pro. it has the 19.5 wheels on it. We have a garbage company we do and it will get so bad after so long we cant get that truck out there. How many slots does it have on each side?
 
You must log in or register to reply here.
Back
Top