Search results

oh yea, And the before shots

well this is a job we done today, and since its my best dumpster pad cleaning before and afters (and my only dumpster pad cleaning before and afters since I dont clean concrete) I figured I'd post them.

Anyone have one of these yet? From the video it seems to be doing a pretty good job. Just curious what the diffrence in design is from the older one. http://www.hydrotek.us/acc-twisters-ANTV5.html

Im looking to buy a oil water seperator. I see several diffrent kinds out there, Watermeister, Mighty Mobile, Sirroco. Anyone know how much diffrence there is in these? Or any recommendations on which one would be my best buy?

I have a 12volt cox reel Im trying to get wired up. Anyone give me some insight on how this is supposed to be done? I know it said something about using a circuit breaker, a solenoid , and a switch?

Anyone know what size the seal is that goes in a udor gearbox model 5038.C2? For the seal on the side that goes onto the engine?

If I win it, id throw away my sump pump, and use it to make videos, showing how well sirocco works picking up waste water from truck washing.

anyone ever have a problem with a gear box leaking oil? I cant tell where its leaking from, buts its going somewhere. I filled it back to the middle of the site glass today, checked it later, it was low again. I can see where something has leaked out, just cant see where it is exactly leaking from!

anyone ever clean any frack tanks? if so, what do you use to clean them? just a degreaser and hot water?

How far will a 20hp or a 16hp vanguard pull from a fuel tank?

Im getting ready to run my burner exhaust out the roof of my box truck. Ive replaced a section of the kemlite (transparent top) with aluminum, now I just need to figure out the best way to make it water tight. I was going to use double wall chimney pipe, but at the top im not sure what to use to...

I've got a waybe burner im trying to wire up. ive got a generic wiring diagram im going off of but can someone tell me where I wire the thermostat in at?

I was running a burner on one of my machines tonight, and noticed it was getting really really hot. I changed the thermostat on it, and swapped the 4.8GPM pump on it for a 8gpm. I touched the case real quick on the burner and it melted my glove. Could it have something to do with the thermostat...

Ive been trying to change the thermostat on my hydrotek unit but I cant get the bushing out the thermostat probe screws into. The probe has diffrent threads then the general thermostate has. The bushing is stuck in the hex manifold. Its like its welding together! Wont budge a bit. Anyone ever...

Anyone kno if udor makes a 8gpm pump around 1800psi? It'll be goin on a 16hp w/ a 12v burner.

get you some flue adapters and vent it out the top.

Does general have a gear box that will fit a ts1041? It says it has a 35mm shaft. I'm wanting to put it on a 16hp vanguard

I need a good filter that I can put in between my filler line and my water tank, we have some jobs that get there water from wells, and the water in my tank starts looking merky. Then the trucks we wash have a film on them. Any suggestions?

anyone ever coverted there machine to run off natural gas/propane? They say a 20lb cylinder is about the same as 5 gallons of fuel. I know all the schwans trucks run off natural gas. I looked into buying one of those a while back. Would be pretty kewl to run my machine, truck, and burner off one...

I bought a machine a while back that was missing the pump, I replaced it and a few other things. I hooked the burner up, and when you turn it on you can feel like there is air blowing but no heat. Im pretty sure its wired up right. Any suggestions?