Fcs_llc
New member
Good evening,
I ran into some problem with my surface cleaner where it is vibrating and not performing the way it should. Upon inspection I notice that the rotary arm is a bit bent and one of the nozzle fittings is seen at an angle compared to the other.
My question is the following. If I wanted to replace the arm, how would I go about doing so? It seems as if you need to unscrew it but is there a certain procedure or tool used to do this?
Look forward to hearing your feedback!
I ran into some problem with my surface cleaner where it is vibrating and not performing the way it should. Upon inspection I notice that the rotary arm is a bit bent and one of the nozzle fittings is seen at an angle compared to the other.
My question is the following. If I wanted to replace the arm, how would I go about doing so? It seems as if you need to unscrew it but is there a certain procedure or tool used to do this?
Look forward to hearing your feedback!