JimFergerson
New member
I just installed a Ts2021 lastnight and did a job this mourning... we've been down for more than a week, and now we're trying to play "catch-up"!
Went from from a 4GPM pump to a 5.6GPM pump with a 13HP Honda. I'm only guessing we're pushing about 2,600psi?
After the install, the motor sounded like a jet getting ready to take off, so I had to bump the the idle down a bunch. The RPM's don't increase in bypass, either.
When I flipped the switch on for hot water, the burner began kicking grey smoke. After about an hour, it started turning black and looking like someone was burning a stack of newspapers... so, I shut it down.
I obviously need to get it into the shop on Monday... (next week), to get it dialed in. At this point, I'm guessing figuring out a new burner nozzle size and a new tip size.
Just trying not to lose any much needed jobs over the weekend, ya know?:thud:
Went from from a 4GPM pump to a 5.6GPM pump with a 13HP Honda. I'm only guessing we're pushing about 2,600psi?
After the install, the motor sounded like a jet getting ready to take off, so I had to bump the the idle down a bunch. The RPM's don't increase in bypass, either.
When I flipped the switch on for hot water, the burner began kicking grey smoke. After about an hour, it started turning black and looking like someone was burning a stack of newspapers... so, I shut it down.
I obviously need to get it into the shop on Monday... (next week), to get it dialed in. At this point, I'm guessing figuring out a new burner nozzle size and a new tip size.
Just trying not to lose any much needed jobs over the weekend, ya know?:thud: