JimFergerson
New member
We're getting ready to close a deal on a new pump.
Going from a Landa LT4035/L to a TS2021 pump on a Landa PGHW4-3000 with a 13hp Honda.
We did the math, and we're expecting about 2,600psi.
I will be installing a 18-20hp motor sometime in the future...
The Landa specs seem to be top secret information, so I can't find any info on the LT4035.
So my question is, am I going to run into any problems mounting the General Pump onto the existing pump rail/bracket, or going from a 25mm to 24mm shaft. And should I consider installing a new Unloader?
Going from a Landa LT4035/L to a TS2021 pump on a Landa PGHW4-3000 with a 13hp Honda.
We did the math, and we're expecting about 2,600psi.
I will be installing a 18-20hp motor sometime in the future...
The Landa specs seem to be top secret information, so I can't find any info on the LT4035.
So my question is, am I going to run into any problems mounting the General Pump onto the existing pump rail/bracket, or going from a 25mm to 24mm shaft. And should I consider installing a new Unloader?