Steel Eagle help

[CompletelyClean]

Just assembled my new 24" Steel Eagle surface cleaner.

Can someone please advise on how I can set up the handle with a wand so that I do not have to shut the machine down to switch from the cleaner to a wand when I get to those small corners, etc.?

Attached is a pic and I will post another right after this one.

 

[CompletelyClean]

2nd picture

attached

 

[ron p]

ron p

on the welded on fitting,you install a quick disconnect fitting[QD].
I dont know if you use a male or female on the end of your pressure hose but i'll guess a female.
If you do use a female, you need to install a male fitting to the top of the welded fitting.
Then buy a high pressure ball valve that you will install a QD fitting on both ends. One a male, the other a female.
this replaces the use of a trigger gun.
So here you go.
pressure line to QD,QD to valve,valve to QD,QD TO QD that is installed to the welded threads.
Turn valve on to run surface cleaner, shut off valve to stop it.
Dis-connect the QD by the welded fitting and attach wand.
Because you have the ball valve you will not need a trigger gun.
If you use hot water,and im sure you do, you need an insulated wand. A side handle aslo helps.

 

[Hotwaterwizard]

Maybe you can get some Ideas from this!