Getting air to my PW in my enclosed trailer

Clean County PW

Clean County PW

Active member
Hey Wiz,
I have a Landa PGHW (Hot water 3000psi PW) in my enclosed trailer that has a fold down ramp for entrance and no side doors. I have this PW mounted in the middle of this trailer with the burner vented thru the roof and the exhaust vented out by the ramp.

So far this PW is running great. Once it warms up around here I'm concerned that it may get to hot in my trailer causing the PW not to run to good because of the lack of airflow since there is no side door entrance to this trailer to compliment the ramp opening.

Since this PW has a generator on it should I put a Fan next to it in my trailer and have it run everytime the PW is on? And if I do this should the fan be facing IN towards the PW to bring the cooler air from the outside in? Or should I have the fan facing OUT towards the PW to blow the air out of the trailer?

What do you think?

Thanks
 
ron p

im not the wiz but since your venting the hot air out from the burner and have the motor pushing the hot exsaust out the rear i think it will be OK
im sure that on the flywheel of the motor there are fins as the motor spins they move the air around the motor to cool it. Thats why there are vents around the pull start.
They make vents that are easy to install in the side of your trailer that you can open and close.
I would just install one by the unit.
 
Last edited:
You must log in or register to reply here.
Back
Top