Enclosed Trailer Flue System - Help!!!

Matthew Norman

Matthew Norman

Moderator
I need help setting up a flue system for my enclosed trailer.

Does anyone know where I can buy this equipment; does any distributors here sell it?
 

Attachments

  • enclosed-flue.jpg
    enclosed-flue.jpg
    31.3 KB · Views: 60
Matt, I've got a funnel type of adapter that was made for a Hydro Tek that the customer ended up putting on an open trailer. I'll get a pic of it later and post it for you. Any HVAC sheet metal shop ought to be able to make one for you. Make sure to leave a small air gap at the machine, so it'll draw easier and prevent soot buildup.
 
As far as the adapter if you are good with sheet metal and have a brake do it yourself if not a HVAC contactor could make an adapter up in minutes for one of those. For the pipe you can run triple wall 8" or 10" to the roof and then attach it to a roof vent with a flexible and removable attachment ( do both ends top and bottom that way for maintinance.) Then any cap you want on top.
 
Russ Johnson said:
P5020013.jpg


P5020014.jpg


P5020015.jpg


My cost on this was about $80.00. It's heavy gauge galvanized steel and adapts to 8" round.
Click to expand...

Thanks for the offer. I think I am just going to pick up the adapter peice made for my unit from Royce Industries tomorrow. My burner has the screw holes and everything already in place.
 
If you allready have the adapter to get it to a round duct you are golden. Don't forget a air gap for draft the coil cleaning will be much easier down the road.
 
You must log in or register to reply here.
Back
Top